Flintec II IPC - Manual (Page 29)

FlintWeigh II IPC Technical Manual, Rev. 1.06 November 2011 Page 29 of 36
9. Legal for Trade Operation
9.1. EC Type-approval and Test Certificate
See documents on the enclosed data medium or on the harddisk of the pre-installed FlintWeigh II terminal
(C:\install\WSC\Conformity\).
9.2. Digital Descriptive Plate
The digital descriptive plate will be displayed after opening the service functions (window FlintWeigh II Settings)
and selecting the register „Information“:
Fig. 9.1 Digital descriptive plate
The digital descriptive plate must conform to the
physical descriptive plate.
(1) Version and revision of the software, checksum in
legal for trade applications in parentheses
(2) Hint area in non-approved applications
(3) Metrological symbol "M": green = approved, red =
not approved
(4) No. of EC type-approval
(5) Electronic calibration counter "TAC"
(6) Logo and address of the owner of the EC type-
approval
(7) Parameters of the selected scale
(8) Parameters of the weighing system controller and
the LDUs
Here you can also enable the 10-times higher resolution
display mode.
9.3. Recording of Weight Values in the Alibi Memory
Fig. 9.2 Successful recording of weight values
Click the button within the weight display
The window „Information“ will be opened:
Here the record no. and the weight value to record will be
displayed.
For transfering them into the alibi memory click the “OK“ button.
Fig. 9.3 Prevented recording of weight values
If the error message „Recording is not possible“ appears, then
the scale was in motion or any of the enabled record locks (see
register „Parameters“) has prevented the successful recording.