FloAire Canopy Hood - Manual (Page 22)

22
Wrapper (Enclosure Panel) Installation
1. Unpack the wrapper panels from the shipping container, being very careful not to dent or scratch
the panels. NOTE: Report any damage to the delivering freight carrier and file a claim if
appropriate.
2. Locate one of the side wrapper panels and position it on the hood so that the 1/2” flange on the
bottom of the panel slips underneath the side channel on top of the hood. See Figure 14A:
Wrapper Detail. NOTE: A notch will have to be cut on the wrapper flange using shears (tin
snips) where interference occurs, where applicable. See Figure 14B: Top Hood Seam Detail.
3. Press fit panel into place until wrapper face is flush with hood face. Screw or pop-rivet wrapper to
the side channel and wall. See Figure 14C: Wrapper Detail and Rear Wall Attachment.
4. Locate front wrapper panel. Position its lower 1/2” flange under front channel on hood and slide
panel into position, so that the end of front panel is behind the 90 degree bend of the side panel.
See Figure 14D: Front Corner Assembly. Once in place, press fit the lower flange of the front
panel into the front channel in order to have wrapper face flush with the front of the hood. Screw
or pop-rivet bottom of front panel to the front channel.
5. Drill appropriate holes and rivet front to side wrapper panel. See Figure 14D: Front Corner
Assembly.
6. If multiple panels are used, a stainless trim piece will be provided to attach multiple panels
together (i.e. hood is side to side, hood is back to back to another, or the wrapper length exceeds
16 feet). Attach the panels by slipping them behind the stainless trim and fastening with screws
or rivets. See Figure 15. NOTE: Trim will have to be cut to fit. In most instances, trim should
extend from bottom of hood to top of wrapper panel.
7. Locate the other side panel. Repeat steps 2 and 3. Attach to front wrapper panel as instructed in
step 4. NOTE: In most instances where hood is located against a side wall, fasten the front
wrapper panel to the wall. See Figure 14E: Side Wall Attachment.
8. Caulk all gaps and seams after the hood(s) and hood accessories have been installed.
Wrapper Detail
Figure 14A
Top Hood Seam Detail (Not on all models)