FloAire Canopy Hood - Manual (Page 29)

29
Vertical End panel Installation
1. Refer to Figure 20.
2. Follow steps 1 & 2 of the end-panel Installation instructions.
3. Position the end panel with the top located flush against the bottom of the hood end and the rear
flange located flush against the rear wall and facing toward the interior of the hood. Studs on
bottom of hood ends should align with slots on top of vertical end panel. Refer to Figure 20.
4. Adjust legs to create slight tension between the vertical end panel and bottom of hood. Confirm
that the top side of the vertical end panel is flush with the bottom of the hood.
5. Secure the rear flange to the wall using stainless steel sheet metal screws, being sure to keep the
end panel straight vertically.
6. Caulk all seams between the vertical end panel and the hood after the hood(s) and hood
accessories have been installed.
Vertical End panel Installation (Hoods with Flanges on Ends)
Figure 20