FloAire Demand Control Ventilation System - Manual (Page 27)

A0023662
May 2014 Rev.5
27
4. Set Number of Fan Switches
This defines the number of fan switches controlled by the system. There can be 0 or 1 fan
switch. A fan switch will be displayed on the HMI accordingly. If 0 is selected, the fans will be
only controlled by the temperature sensors.
5. Set Number of Light switches
This defines the number of hood light switches controlled by the system. There can be 0, or 1
light switch. A light switch will be displayed on the HMI accordingly.
6. Set Proving Interlock
This option enables or disables the Fan Proving Interlock. Refer to the Fan Proving Interlock
paragraph under Functionality for further details. If this option is enabled, Proving calibration is
required. Refer to paragraph e under Setup Options.
7. Set Hood CORE
This option determines if the system is connected to a CORE Fire Protection system.
8. Set Wash
This option determines if the system includes a self-cleaning option. This option will not be
available if CORE is enabled.
9. Set Prep Time Enable
This option enables or disables the Preparation Time mode. Refer to the Preparation Time Mode
paragraph under Functionality for further details.
10. Set KTS
This option determines if a Kill switch or Tamper switch are connected to the system. If this
option enabled, the input KTS shall be maintained energized for normal cooking operations. If
KTS is deenergized, an electric gas valve connected to the system would drop and the shunt trip
output will be energized.
11. Fan Controller type
For each Fan, this option determines the type of Controller being used. Two (2) options are
available: 571 and 531. If 571 is selected, the ECPM03 will communicate to a VFD with part
number ending in 571. Typically these VFDs are 10 HP and below. If 531 is selected, the
ECPM03 will communicate to a VFD with part number ending in 531. Typically these VFDs are
15 HP and above.
Press MENU multiple times to get back to the main menu or one more time to reboot the processor.