FloAire Demand Control Ventilation System - Manual (Page 30)

A0023662
May 2014 Rev.5
30
Temperature Sensor
The temperature sensor is a 10K Ohm Thermistor. The
sensor gives constant feedback to the controller. One
sensor is installed in every riser.
Room Temperature Sensor
The Room temperature sensor is a 10K Ohm Thermistor. The sensor provides constant
room temperature to the controller. It should be installed on a wall somewhere in the
space but not directly under the hood or close to an appliance so that the reading is not
affected by heat.
Typically a system will have one room temperature sensor. However systems
configured with 2 fan zones have the option to be ordered with 2 room temperature
sensors, one for each zone. They should be mounted in the space accordingly.
HMI
The HMI is designed to withhold grease and water when installed on
the face of the hood or utility cabinet.
The Interface is connected to the ECPM03 through a CAT-5 cable. If
the interface is installed on the face of the hood, a high temperature
CAT-5 Cable is used.
The HMI can be mounted to a standard 2-gang junction box.