Glossary, Unpack the box, Get the model ready to fly – Flyzone FLZA2000 User Manual

Page 3

Advertising
background image

3

GLOSSARY

Lithium Polymer (LiPo) Battery: Rechargeable battery which is

used to power the airplane. LiPo batteries are lighter and smaller
than most other types of rechargeable batteries.

Transmitter (TX): This is the hand-held unit that sends the

signal to the control unit, or RX.

Rudder: Controls turning direction.
Elevator: Controls altitude.

UNPACK THE BOX

Check the parts against those shown below. If any parts are
damaged or missing, give us a call at: (217) 398-8970.

GET THE MODEL READY TO FLY

PREPARE THE TRANSMITTER

1. Remove the battery
cover on the back of the
transmitter and insert fi ve
“AA” batteries according
to the diagram printed in
the battery compartment.
Reinstall the battery door.

TRANSMITTER CAUTIONS

• Do not use rechargeable (NiCd) batteries.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable

(NiCd) batteries.

CHARGING THE PLANE’S LIPO BATTERY

1. Open the charge lead door on the back of the transmitter by
sliding it out and then swinging it open.

IMPORTANT!

NEVER LEAVE A CHARGING BATTERY UNATTENDED!

WARNING!! Failure to follow all instructions could cause
permanent damage to the battery and its surroundings, and
cause bodily harm!

• ONLY use the Playmate transmitter or optional 1S charger to

charge the LiPo battery.

• ALWAYS charge in a fi reproof location.
• NEVER allow battery temperature to exceed 150°F [65°C].
• NEVER disassemble or modify pack wiring in any way or

puncture cells.

• NEVER place on combustible materials or leave unattended

during charge or discharge.

• ALWAYS KEEP OUT OF REACH OF CHILDREN.
• Unplug the battery if it gets warm, even if the left LED has

not gone out.

WARNING: Misuse or malfunction may overheat the battery

and charger, resulting in personal injury or damage to
surroundings.

Advertising