Flyzone FLZA2000 - Manual (Page 6)

6
4. If the elevator does not move in the correct direction according
to step #1, you can reverse its movement by pressing and holding
either elevator trim button and switching on the power to the
transmitter. You will hear three fast beeps confi rming the change.
5. If the rudder does not move in the correct direction according
to step #2, you can reverse its movement by pressing and holding
either rudder trim button and switching on the power to the
transmitter. You will hear three fast beeps confi rming the change.
6. If the rudder is operating on the left control stick, turn off the
transmitter, move the left control stick to the upper left position,
the right control stick to the upper right position, and then turn
on the transmitter. The transmitter will make three quick beeps
followed by one or two longer beeps. Test the operation of the
rudder and confi rm the change. This procedure toggles the
rudder function between the left and right control sticks.
ADJUSTING THE CONTROL TRIMS
1. Before making your fi rst fl ight, use the trim buttons for the right
control stick to center the elevator and rudder. Adjust the trim as
necessary using the trim buttons until the elevator and rudder are
inline with the horizontal stabilizer and vertical fi n as shown.
2. If additional trim is required beyond what the trim buttons
are capable of (when the maximum trim has been reached, the