Flyzone HCAA28 - Manual (Page 10)

10
❏ 5. Use a straight edge to check that the elevator
is centered. If it is not centered, loosen the thumb
screw and adjust the elevator. When you are
satisfi ed, tighten the thumb screw.
❏ 6. Check the rudder and make sure it is centered.
If it is not centered, adjust it as you did the
elevator above.
FINISH THE RADIO SETUP
The control throws (the distance of control surface
defl ection) are measured at the widest part of the
elevator and rudder. If it is necessary, adjust the
position of the pushrods at the servo arms and
the control horns to change the amount of throw.
Moving the pushrod out away from the center
of the servo arm or in on the control horn will
increase the amount the control surface moves.
❏ 1. When viewing the airplane from the aft end,
move the right control stick to the right. The rudder
must move to the right. If it does not, change the
position of the rudder servo reversing switch on the
transmitter. With the stick moved all the way over
to the right, the trailing edge of the rudder should
move to the right 7/16" [11mm]. When the stick is
moved all the way to the left, the trailing edge of
the rudder should move to the left 7/16" [11mm].
❏ 2. Moving the right control stick all the way down
should make the elevator move up. If it does not