Flyzone HCAA28 - Manual (Page 7)

7
❏ 3. Holding the fuselage in one hand and the
Power Pod in the other, slide the Power Pod into
the forward part of the slots in the fuselage. Make
sure that all of the tabs are inserted. NOTE: Photos
show the left side of model.
❏ 4. Push the Power Pod up into the fuselage and
slide it backwards until it stops. The tabs on the
Power Pod should be fully engaged onto the wing
spar sleeves.
❏ 5. Locate the left and right Power Pod locks. Insert
the tab of each Power Pod lock into the forward
part of the forward slots. These will lock the Power
Pod in place. NOTE: If you have diffi culty installing
the locks, the Power Pod must be slid back farther.
Remove and reinstall the Power Pod, making sure
to slide the pod all the way back in the slots.
Removing and reinstalling the wings many
times may loosen the fi t of the Power Pod locks
in the slots. Wrapping the tabs with masking
tape will help improve the friction fi t.
❏ 6. Connect the red motor wire of the Power
Pod to the red wire of the ESC. Connect the black
motor wire to the black ESC wire. Position these
wires in the fuselage so that they do not interfere
with the two servos.