Flyzone HCAA28 - Manual (Page 9)

9
❏ 2. Peel the backing paper off of the “hook” side
of the hook and loop material. Position the battery
all the way forward in the battery compartment
and press it into place. Pull the battery out of the
airplane. The hook side should remain stuck to
the battery compartment fl oor.
❏ 3. Install the nosecone as shown. A magnet
holds it in place.
ADJUST THE RADIO
❏ 1. Set the airplane down on a fl at surface that is
clear of any debris. Keep loose clothing, sweater
strings, and all other foreign objects clear of the
EDF unit at all times.
❏ 2. Move the throttle stick all the way down and
switch on the transmitter. Make sure that all three
LEDs are on. If the green LED is not on, you need
to replace the transmitter batteries. CAUTION:
The transmitter must always be turned on BEFORE
plugging in the LiPo battery.
❏ 3. Insert the LiPo battery into the airplane,
connect the battery, and move the switch on the
ESC to the ON position. CAUTION: Once the battery
is connected to the ESC, stay clear of the EDF unit.
❏ 4. Center the trim sliders on the transmitter.