Flyzone HCAA28 - Manual (Page 4)

4
LITHIUM BATTERY HANDLING & USAGE
WARNING!!
Read the entire instruction sheet included
with the battery charger. Failure to follow all
instructions could cause permanent damage
to the battery and its surroundings, and cause
bodily harm!
• ONLY use a LiPo approved charger.
• NEVER charge in excess of 4.20V per cell.
• ONLY charge through the “charge” lead. NEVER
charge through the “discharge” lead.
• NEVER charge at currents greater than 1C.
• ALWAYS set charger’s output volts to match
battery volts.
• ALWAYS charge in a fi reproof location.
• NEVER trickle charge.
• NEVER allow battery temperature to exceed 150°
F (65° C).
• NEVER disassemble or modify pack wiring in any
way or puncture cells.
• NEVER discharge below 2.5V per cell
• NEVER place on combustible materials or leave
unattended during charge or discharge.
• ALWAYS KEEP OUT OF REACH OF CHILDREN.
PREPARE THE TRANSMITTER
❏ 1. Install the antenna into the transmitter by
screwing it on until tight.
❏ 2. The transmitter is the unit that controls your
airplane and requires eight good quality “AA”
batteries. To install the batteries, remove the
battery hatch on the back of the transmitter.
❏ 3. Pull the battery holder out of the transmitter
case and install eight new “AA” batteries, following
the diagram on the holder.
❏ 4. Insert the battery holder in the transmitter case
so that the two contacts on the battery holder align
with the contacts in the transmitter case. Reinstall
the battery hatch on the transmitter case.