Flyzone HCAA28 - Manual (Page 8)

8
INSTALL THE BEGINNER WING
❏ 1. Position the 8mm x 225mm wing joiner tube
in the fuselage as shown. It does not have to be
centered in the fuselage exactly. It will self-center
when you install the wings.
❏ 2. Install the wings, one at a time, onto the wing
joiner tube. As you install each wing, be careful
to align each wing peg with its respective sleeve
in the fuselage. Slide the wings onto the fuselage
until they sit fl at against the fuselage. Two magnets
in each wing will keep the wings attached.
FINAL EDF UNIT CHECK
With the airplane off and the battery removed, use
a phillips screwdriver to check to see that the fan is
securely screwed onto the motor. Periodically, you
should remove this screw and pull off the fan to
check the two screws inside that attach the motor
to the EDF unit. Use thread-locking compound on
the threads of these screws and the fan screw and
reinstall them tightly. Over-tightening these screws
can cause the EDF unit to crack and become unsafe.
PREPARE THE BATTERY
❏ 1. Peel the backing paper off of the “loop” side
(fuzzy side) of the hook and loop material that was
supplied with your Diablo EDF. Stick the loop side
to the back of the battery as shown.