Flyzone HCAA1985 - Manual (Page 4)

❏ 1. The decals for the Sky Pilot are already cut-out
on the decal sheet. Peel the decals off of the sheet
and apply them to the plane using the box as a guide
to their location.
❏ 2. Insert the fin into the fin holder. Use two
medium screws to attach the fin to the holder. Be
careful to not over tighten the screws.
(If you have the Ready-to-Fly version of the Sky Pilot
with the radio system already installed, skip to
PREPARE THE TRANSMITTER, page 5.)
❏ 1. Follow the manufacturer’s instructions to install the
rubber bushings and metal grommets in both servos.
❏ 2. Use the screws, included with your servos, to
attach the servos to the servo tray. Note that both
servo arm output shafts are towards the front.
❏ 3. Clean the back side of the receiver (not
included) with rubbing alcohol. Apply double-sided
tape (not included) to the back of the receiver. Then,
install the receiver in the fuselage, on top of the
battery holder.
❏ 4. Route the antenna through the antenna tube,
located at the top back of the servo tray, and out the
tail of the fuselage. Caution: Do not cut the excess
antenna exiting out the aft end of the fuselage.
Cutting the antenna will reduce the range of the
radio system.
❏ 5. Plug the right servo into the elevator servo
socket and the left servo into the rudder servo socket
of the receiver. Note: If using a 4-channel, 2-stick
transmitter, modelers that are just learning to fly will
have fewer problems if the rudder servo is plugged
into the aileron socket of the receiver. This will allow
the right stick to be used for the rudder and elevator.
RADIO INSTALLATION
(ALMOST-READY-T0-FLY VERSION)
INSTALL THE FIN
4
x 2
ACTUAL SIZE