Flyzone HCAA1985 - Manual (Page 9)

❏
3. To start the motor, the throttle lever must first be
“OFF”, all the way to the left when switching on the
transmitter and plane. Then move the lever all the way to
the right and hold it there for 5 seconds. Then return the
lever to the left. This will “arm” the motor. The motor will
now operate when the throttle lever is moved to the
right. NOTE: Arming the motor will need to be done
each time after the transmitter has been turned OFF!
❏ 1. At the front edge of the wing are two small posts.
Position the wing on the top of the fuselage and slide
the wing forward, inserting the posts in the holes on
the fuselage. Fasten the wing to the fuselage with the
large screw and metal washer. The screw should be
tight enough to hold the wing snug against the
fuselage, yet does not crush the wing.
❏ 2. Turn the plane over and attach the wing struts to
the battery tray and the wing with four small screws.
Important: The Sky Pilot must never be flown without
the wing struts attached. The wing struts help support
the wing.
Note: This section is VERY important and must NOT
be omitted. A model that is not properly balanced
will be unstable and possibly unflyable.
❏ 1. After the battery pack is charged, open the battery
hatch. Insert the battery pack inside the fuselage. Do not
plug the battery pack into the connector inside the
fuselage. Close the battery hatch.
CHECK THE BALANCE OF THE MODEL
INSTALL THE WING
9
x 4
ACTUAL SIZE
x 1
ACTUAL SIZE