Futaba 3PJS - Manual (Page 67)

67
SELECT Mode Functions
Lap Navigation Timer
Lap Navigation Timer Function
- Use this function when you want to generate an audible alarm at a fixed interval.
Since only the audible alarm can be restarted while the timer is operating, this func-
tion can also be used as a target time during practice runs, etc. (Navigation buzzer)
- The timer is started and stopped each time the switch is operated and the accumu-
lated time from start to stop is displayed. (When the count reaches 99 minutes 99
seconds, it returns to 00 minute 00 second and counting is repeated.)
- Initial starting can be linked to the throttle trigger.
- Audible alarms (alarm/prealarm) can be set independently from the fixed interval
buzzer.
Alarm: An audible alarm is heard at the set time.
Prealarm: An audible alarm is heard the set time before the alarm.
-After starting, the timer is effective even if the display is switched to another screen.
The timer is stopped by switch.
Lap Navigation Timer Setting
1. Call the timer screen by
pressing the DOWN key
twice at the initial screen.
- 2 times
2. Call the timer type selection
screen by pressing the SE-
LECT key once.
3. Select LN with the + or - key.
4. (Alarm setting)
Call the alarm set-up screen
by pressing the SELECT key
once.
5. Set the alarm time with the +
or - key.
Setting range: OFF, 1~99m
m: minute
- Return to the initial value (4m) by
pressing the + and - keys simulta-
neously for about one second.
Blink
Blink
Blink
Blink
DIRECT ST.EXP M.SEL
UP +
SETUP RESET
SELECT DOWN -
TH.EXP ATV CUSTOM
DIRECT ST.EXP M.SEL
UP +
SETUP RESET
SELECT DOWN -
TH.EXP ATV CUSTOM
DIRECT ST.EXP M.SEL
UP +
SETUP RESET SELECT DOWN -
TH.EXP ATV CUSTOM
DIRECT ST.EXP M.SEL
UP +
SETUP RESET
SELECT DOWN -
TH.EXP ATV CUSTOM
DIRECT ST.EXP M.SEL
UP +
SETUP RESET
SELECT DOWN -
TH.EXP ATV CUSTOM