Philips 54XP43C/37 - Manual (Page 14)

□I
F eature M enu C ontrols ( continued )
<i>
ADD/DELETE CHANNELS
A uto-Programming (see
previous page) adds all the
channels it can find (on your
Antenna or Cable TV system ) into
the TV's memory. AddID elete
Channels makes it easy for you to
add other channels, or drop
unwanted channels, from the lisrof
channels in the TV's memory.
t BEGIN]
Select CHANNEL MEMORY
(ADD/DELETE CHANNELS)
control.
With the FEATURES MENU on
screen, move the RED highlight
with the MENU (M) ◄•►buttons.
Then press the MENU button.
<l>
Press the CHANNEL AT or
number buttons to select the
channel you want to add or delete.
<l>
Press the MENU ^ button to
ADD the channel into the TV's
memory.
Press the MENU ^ button to
DELETE the channel from
memory.
Repeat steps 2 and 3 for each
channel you wish to add or delete.
Press the STATUS or MENU
button to clear the screen when
through.
S mart H i ; i . i >
Remember. You can also
i add the AUX 1, AUX 2, or
AUX 3 modes just like a channel.
Then by pressing the CHANNEL
A'T buttons the AUX(iliary)
mode can quickly be selected to
use the desired set of Input Jacks
on the TV (see page 28).
Note: AUX 1, AUX 2, and AUX 3
modes are located between the
lowest and highest channel
numbers within the
ADD/DELETE CHANNEL
control screen.
k
o
Pi 1
ox
foN/WH POS H
swap
H
№ttg
r
Channel 19 Added
for ANT A
J
¡mM
...
SELECT CHANNEL
(D to DELETE CHANNEL
for ANT B
when FINISHED
NOTE: A separate ADD/DELETE CHANNEL memory
may also be created for the ANT(enna) B Input on the
rear of the set (if an Antenna or Cable TV signal has been
connected). Just press the button on the remote,
while in the ADD/DELETE CHANNEL mode, to switch
between the ANT A and ANT B channel memory lists.
Then follow steps 2 and 3 as shown to the left to add or
delete the desired channels.
14