Future Retro Swynx - Manual (Page 20)

CHECKING YOUR PATTERNS
•
Press the Start/Stop switch of the CR-78 to stop programming.
•
Set the CR-78 Programmer switch to the PLAY position, remove the
cable going to the CR-78’s clock IN jack, then press Start/Stop to
play the CR-78 and hear the results.
•
If mistakes are made, clear individual instruments by setting the
Programmer switch to MEMORY, select the appropriate instrument,
and press the CLEAR key on the CR-78. To clear all instrument
tracks, set the Programmer switch to ALL, then press the CLEAR
key.
•
If patterns need further editing, make sure playback of the CR-78 is
stopped. Reinsert the cable into the CR-78’s clock IN jack, and press
the Start/Stop switch of the CR-78 before proceeding with step
writing.