Gaggia CAREZZA - Manual (Page 20)

• 20 •
4 Installation
For your own and other people safety, carefully follow
the "Safety Regulations" indicated in chapter 3.
4.1 Packaging
The original packaging has been designed and manufactured
to protect the machine during transport. We recommend
keeping the packaging material for possible future transport.
4.2 Installation Precautions
Do not move the machine by grabbing the cup
protection grilles.
Before installing the machine, read the following safety pre-
cautions carefully:
• Place the machine in a safe place.
• Make sure children cannot play with the machine.
• Do not place the machine on hot surfaces or near open
fl ames.
The coff ee machine is now ready to be connected to the electric
network.
Note: we recommend washing the components
before using them for the fi rst time and/or af-
ter they have not been used for a certain period of time.
4.3 Water tank
• 1 Remove the water tank (5).
• 2 Rinse it and fi ll it with fresh drinking water, making
sure that the (MAX) level indicated in the tank is not ex-
ceeded.
Fill the tank only with fresh, non-sparkling,
drinking water. Hot water or any other liquid
may damage the tank. Do not operate the machine
when the water level in the tank is below the MIN
threshold. Make sure there is enough water in the wa-
ter tank.
• Insert the water tank back into its seat in the coff ee ma-
chine and make sure that it locks into place - its profi le
should adhere to that of the coff ee machine.
Note: the water level can be checked looking
through the window on the front side of the
tank.
4.4 Machine Connection
Electric power may be very dangerous! It is
therefore necessary to strictly follow the safety
regulations. Do not use faulty power cords. Faulty cords
and plugs must be replaced immediately by Authorised
Service Centres.
The voltage of the appliance has been pre-set by the manu-
facturer. Check that the voltage matches the indication on the
data plate at the bottom of the appliance.
•
3A Insert the plug into the socket on the back of the ma-
chine.
• 3B Insert the other end of the plug into a wall socket with
suitable power voltage.
4.5 First Use
At fi rst start-up, the coff ee machine circuit must be primed.
4 Press the ON/OFF button (11): the " " light (12) turns on
and the " " (14), " " (20) and " " (18) lights blink,
prompting the user to prime the circuit.
5 Place a container under the steam wand (Pannarello).
Open the "hot water/steam" knob (3) by turning it clock-
wise. The pump is activated automatically. Wait until
a steady jet of water fl ows out of the steam wand (Pan-
narello).
6 Close the "hot water/steam" knob (3) by turning it coun-
ter-clockwise. Remove the container.
The machine begins the warm-up phase only after the water
circuit has been correctly primed.
Note: if the knob is left open, the pump is auto-
matically disengaged after a few seconds and
the " " light (20) starts blinking.
4.6 Circuit Priming
When the water tank is empty, the machine circuit must be
primed again.
Note: if the machine has been operating with-
out water for a lot of time and the "
" (14), "
" (20) and " " (18) lights are blinking, please refer
to the "Troubleshooting" table.
• 5 Place a container under the steam wand (Pannarello).
• Open the "hot water/steam" knob (3) by turning it clock-
wise. The pump is activated automatically.
• Wait until a steady jet of water fl ows out of the steam
wand (Pannarello).