Instruments and controls 5-21 – GMC 2012 Savana User Manual

Page 135

Advertising
background image

Black plate (21,1)

GMC Savana Owner Manual - 2012 - 2nd - 11/11/11

Instruments and Controls

5-21

Notice: Modifications made to the
engine, transmission, exhaust,
intake, or fuel system of the
vehicle or the replacement
of the original tires with other
than those of the same Tire
Performance Criteria (TPC) can
affect the vehicle's emission
controls and can cause this light
to come on. Modifications to
these systems could lead to
costly repairs not covered by the
vehicle warranty. This could also
result in a failure to pass a
required Emission Inspection/
Maintenance test. See
Accessories and Modifications on
page 10‑3
.

This light comes on during a
malfunction in one of two ways:

Light Flashing: A misfire condition
has been detected. A misfire
increases vehicle emissions and
could damage the emission control
system on the vehicle. Diagnosis
and service might be required.

To prevent more serious damage to
the vehicle:

.

Reduce vehicle speed.

.

Avoid hard accelerations.

.

Avoid steep uphill grades.

.

If towing a trailer, reduce the
amount of cargo being hauled as
soon as it is possible.

If the light continues to flash, stop
and park the vehicle. Turn the
vehicle off, wait at least 10 seconds,
and restart the engine. If the light is
still flashing, follow the previous
steps and see your dealer for
service as soon as possible.

Light On Steady: An emission
control system malfunction has
been detected on the vehicle.
Diagnosis and service might be
required.

The following may correct an
emission system malfunction:

.

Check that the fuel cap is fully
installed. See Filling the Tank on
page 9‑43
. The diagnostic
system can determine if the fuel
cap has been left off or
improperly installed. A loose or
missing fuel cap allows fuel to
evaporate into the atmosphere.
A few driving trips with the cap
properly installed should turn the
light off.

.

Check that good quality fuel is
used. Poor fuel quality causes
the engine not to run as
efficiently as designed and may
cause stalling after start-up,
stalling when the vehicle is
changed into gear, misfiring,
hesitation on acceleration,
or stumbling on acceleration.
These conditions might go away
once the engine is warmed up.

Advertising