Instruments and controls 5-27 – GMC 2011 Acadia User Manual

Page 159

Advertising
background image

Black plate (27,1)

GMC Acadia/Acadia Denali Owner Manual - 2011

Instruments and Controls

5-27

UNITS

Press the vehicle information button
until UNITS displays. This display
allows you to select between Metric
or English units of measurement.
Once in this display, press the
set/reset button to select between
METRIC or ENGLISH units. All of
the vehicle information will then
be displayed in the unit of
measurement selected.

FRONT TIRES or REAR TIRES

On vehicles with the Tire Pressure
Monitor System (TPMS), the
pressure for each tire can be
viewed in the DIC. The tire
pressure will be shown in either
kilopascals (kPa) or pounds per
square inch (psi). Press the vehicle
information button until the DIC
displays FRONT TIRES kPa (PSI)
LEFT ## RIGHT ##. Press the
vehicle information button again
until the DIC displays REAR
TIRES kPa (PSI) LEFT ##
RIGHT ##.

If a low tire pressure condition
is detected by the system while
driving, a message advising you
add air to a specific tire will appear
in the display. See Tire Pressure on
page 10‑45
and Tire Messages on
page 5‑44
for more information.

If the tire pressure display shows
dashes instead of a value, there
may be a problem with your vehicle.
If this consistently occurs, see your
dealer for service.

COMPASS ZONE SETTING

This display will be available
if the vehicle has a compass.
See Compass on page 5‑6 for
more information.

COMPASS RECALIBRATION

This display will be available
if the vehicle has a compass.
See Compass on page 5‑6 for
more information.

Blank Display

This display shows no information.

Trip/Fuel Menu Items

3

(Trip/Fuel): Press this button

to scroll through the following menu
items:

ODOMETER

Press the trip/fuel button until
ODOMETER displays. This display
shows the distance the vehicle has
been driven in either kilometers (km)
or miles (mi). Pressing the trip
odometer reset stem will also
display the odometer.

To switch between English and
metric measurements, see “UNITS”
earlier in this section.

Advertising