Heli-Max HMXE0200 - Manual (Page 4)

4
❏
3. Secure two tail strut ends and the rear frame spacer
to the frames with two 2x10mm machine screws as shown.
Use a drop of threadlocker to secure each screw.
❏
4. Secure two tail strut ends to the horizontal stabilizer
bracket with 2x8mm sheet metal screws.
❏
5. Insert the carbon fiber tail struts into the strut ends.
Secure each end with a drop of thin CA.
❏
6. Finalize the position of the horizontal stabilizer bracket,
and tighten the horizontal stabilizer screws to hold the
assembly firmly in place. Do not over tighten.
❏
1. With the Z-bend towards the front, slide the rudder
pushrod back through both supports on the tail boom.
❏
2. Screw a ball link onto the threaded end of the
rudder pushrod.
❏
3. Connect the ball link to the ball on the tail rotor pitch
control horn. Check to see that the ball link runs freely on the
ball, and loosen it if necessary using the following Heli-Max Tip.
INSTALL THE PUSHRODS