Heli-Max HMXE0200 - Manual (Page 5)

❏
4. Connect the aileron pushrods as shown. Check the
ball links and adjust the fit if necessary.
❏
5. Connect the collective pitch pushrod as shown. Check
the ball link and adjust the fit if necessary.
❏
6. Connect the elevator pushrod. Check the ball link and
adjust the fit if necessary.
❏
1. Install the aileron servo in its tray. If using the
recommended Futaba servos, you will need to install the
eyelets upside down in your servo, and install the servo
under the tray, with the screws running up into the tray.
❏
2. Center the aileron servo. Install the aileron pushrods
through the servo arm and install the servo arm on the
servo as shown. With the servo centered, the two aileron
control horns should be even with one another. If they are
not, adjust the pushrod until they are. Once you have the
aileron control horns even, check to make sure that the
INSTALL THE SERVOS
HELI-MAX TIP
How to adjust the fit of ball links.
If a ball link does not twist freely on its ball, squeeze it
firmly with a pair of needlenose pliers
while it is
installed on the ball.
5