Heli-Max HMXE0200 - Manual (Page 9)

❏
1. Attach the “loop” side of the hook-and-loop material to
the battery. Mount the battery to the battery tray.
❏
2. For safety, do not install the main blades while
performing bench setup.
❏
3. Lower the throttle stick all the way and turn on the
transmitter. Connect your battery to the ESC. If the ESC has
a BEC switch, turn it on.
❏
4. Check all the servos to see if they are centered. Since
you set the center points as you set up the linkages, they
should already be very close. Use the trims or subtrims on
the transmitter to center the controls.
❏
5. Make certain that the swash plate and the motor
respond in the correct direction as shown in the diagram. To
operate the motor, you may have to “arm” your ESC. Follow
the instructions that came with your ESC to do this. If any of
the controls respond in the wrong direction, use the servo
reversing in the transmitter to reverse the servos connected
to those controls. Be certain the servos have remained
centered. Adjust if necessary.
❏
1. Balance your main blades using the Heli-Max Blade
Balancer (HMXR4855). Do so according to the instructions
that came with your balancer.
❏
2. Attach the main rotor blades. The blades should be
tight enough in the grips to hold their position when moved,
but still move easily by hand.
❏
1. Cut out the pitch template from the last page of this
manual and slip it over one of the main blades.
❏
2. We recommend 8 degrees of maximum collective pitch in
both directions as a starting point. Check to see that the bottom
of the pitch template is level with the flybar at maximum positive
pitch and the top of the template is level with the flybar at full
negative collective pitch. Adjust your linkages or radio endpoints
if necessary to achieve these values.
❏
3. Once you are comfortable with the helicopter, feel free to
increase or decrease this pitch value to suit your flying style.
WARNING: Disconnect the motor from the ESC to prevent
accidental startup while performing pitch adjustment.
ADJUST COLLECTIVE PITCH
BLADE BALANCING & INSTALLATION
COLLECTIVE PITCH INCREASES
MOTOR TURNS
RUDDER PUSHROD
MOVES FORWARD
SWASHPLATE TILTS
RIGHT
SWASHPLATE TILTS
BACKWARD
4-CHANNEL TRANSMITTER
(STANDARD MODE 2)
4-CHANNEL RADIO SETUP
TRANSMITTER 4-CHANNEL
TRANSMITTER 4-CHANNEL
TRANSMITTER 4-CHANNEL
CHECK THE CONTROL DIRECTIONS
9