Heli-Max HMXE0200 User Manual
Page 8
❏
5. Install the speed control on the bottom of the
helicopter with double-sided tape. Connect the ESC to the
motor and receiver.
❏
6. Secure all wiring to the frame with nylon wire ties.
❏
7. Make sure that the receiver antenna is routed so that
it cannot possibly interfere with the main or tail rotor blades.
There are many possible ways to route the antenna, and
you may have to try different methods to get interference-
free operation, but it is essential that the antenna be
constrained against contact with the blades.
❏
8. Attach the hook side of hook and loop fastener to the
battery tray.
❏
9. Cut the window out of the canopy, and trim the flashing
from around the rear opening.
❏
10. Cut the clear shield out along the molded-in cut lines.
❏
11. Secure the shield to the canopy with the two small
screws packaged with the shield.
❏
12. Install the canopy onto the helicopter.
❏
12. Secure the landing gear skids by positioning them
correctly and adding a drop of thin CA at each joint.
8