Heli-Max HMXE0804 - Manual (Page 20)

20
NOVUS CP – REPLACING THE FLYBAR
Loosen the screws on
both flybar paddle collars.
Rotate the paddles counter
clockwise to remove the
paddle and the collar from
the flybar. Loosen the
screws on the flybar carrier
(both sides). At this point
the flybar can be slid out of
the flybar carrier. Slide the
new flybar into the flybar
carrier and ensure that
the new flybar is centered. Tighten the flybar carrier screws and reinstall the
paddles. Ensure that the paddles are equal distances out on the flybar and
tighten the flybar paddle collar screws.
NOVUS CP – REPLACING THE MAIN GEAR
Remove the lower retaining
pin from the main gear
using needle nose pliers.
Remove the old main gear
from the model and install
the new main gear. Align
the hole in the main shaft
with the hole in the main
gear and press the small
pin back through the hole.
NOVUS CP – REPLACING THE MAINSHAFT
Remove the lower
retaining pin from the main
gear using needle nose
pliers.
Disconnect the
servo linkages from the
swashplate. Slide the main
shaft straight up and out of
the main frame. Remove
and transfer necessary
parts to the new main shaft
and reinstall by reversing
the order listed above.