HONDA 2006 S2000 - Owner's Manual - Manual (Page 147)

CONTINUED
Remove the oil filter, and let the
remaining oil drain. A special
wrench (available from your
dealer) is required. Open the hood, and remove the
engine oil fill cap. Remove the oil
drain bolt and washer from the
bottom of the engine. Drain the oil
into an appropriate container.
Install the engine oil fill cap. Start
the engine. The oil pressure
indicator should go out within
5
seconds. If it does not, turn off the
engine, and check your work.
Check the oil filter to make sure
its gasket did not stick to the
engine block. A stuck gasket could
cause an oil leak.
Engine oil change capacity
(including filter):
Refill the engine with the
recommended oil.
Put a new washer on the drain bolt,
then reinstall the drain bolt.
Tighten the drain bolt to:
Install a new oil filter according to
the instructions that come with it.
Make sure to clean off any dirt
and dust on the connecting
surface of a new oil filter.
2.
4.
3.
5.
6.
7.
8.
Changing the Oil and Filter
Ma
int
e
na
nce
145
WASHER OIL DRAIN BOLT OIL FILTER
33 lbf·ft (45 N·m , 4 .6 kgf·m)
5.1 US qt (4.8 )
Main Menu Table of Contents