HONDA 2006 S2000 - Owner's Manual - Manual (Page 157)

Use a small flat-tipped screwdriver
to pry carefully on the back edge
of the side turn signal assembly
until it pops out of the body.
Turn the bulb holder one-quarter
turn counterclockwise to remove it
from the lens.
Pull the bulb straight out of its
socket. Push the new bulb straight
into the socket until it bottoms.
Put the bulb holder back into its
hole in the lens, and turn it
clockwise until it locks.
Turn on the lights to make sure
the new bulb is working.
Put the side turn signal assembly
back into the body, front first.
Push on the back edge until it
snaps into place.
1.
2.
3.
4.
5.
6.
Replacing a Side Turn Signal Bulb
Lights
Ma
int
e
na
nce
155
Main Menu Table of Contents