Homelink universal transceiver – HONDA 2005 Accord Hybrid - Owner's Manual User Manual

Page 148

Advertising
background image

Canadian Owners:

If the button does not work, repeat
this procedure to train it again. If it
still does not work, you may have a
variable or rolling code garage
door opener. See if you do by
pressing and holding the
HomeLink button you just trained.
If the red indicator blinks for 2
seconds, then stays on, you have a
rolling code garage door opener.
Go to ‘‘Training With a Rolling
Code System’’.

Repeat these steps to train the
other two HomeLink buttons to
operate any other remotely-
controlled devices around your
home (lighting, automatic gate,
security system, etc.).

The ‘‘Training HomeLink’’
procedure trains HomeLink to the
proper garage door opener code.
The following procedure
synchronizes HomeLink to the
garage door opener so it sends and
receives the correct codes.

For security purposes, newer garage
door opening systems use a ‘‘rolling’’
or variable code. Information from
the remote control and the garage
door opener are needed before
HomeLink can operate the garage
door opener.

The red indicator in HomeLink
should begin flashing. It will flash
slowly at first, then rapidly.

When the red indicator flashes
rapidly, release both buttons.
HomeLink should have learned
the code from the remote control.

Plug in the garage door opener
motor, then test the HomeLink
button by pushing it.

4.

5.

6.

7.

Training With a Rolling Code
System

HomeLink Universal Transceiver

Fe
a

tu

re

s

147

The remote control

you are training f rom may stop
transmitting af ter 2 seconds. This is not
enough f or HomeLink to learn the code.
Release and press the button on the
remote control every 2 seconds until
HomeLink has learned the code.

Main Menu

Table of Contents

Advertising