HONDA 2005 Odyssey - Owner's Manual - Manual (Page 268)

The HomeLink Universal
Transceiver built into your vehicle
can be programmed to operate up to
three remote controlled devices
around your home, such as garage
doors, lighting, or home security
systems.
If you are training HomeLink to
operate a garage door or gate, you
should unplug the motor for that
device during training. Repeatedly
pressing the remote control button
could burn out the motor.
Always refer to the opening
instructions and safety information
that came with your garage door
opener or other equipment you
intend to operate with HomeLink. If
you do not have this information,
contact the manufacturer of the
equipment.
To do this, press and hold the two
outside buttons on the HomeLink
Transceiver for about 20 seconds, or
until the red indicator flashes.
Release the buttons, then go to step
1.
If you are training the second or
third buttons, go directly to step 1.
If you just
received your vehicle and have not
trained any of the buttons in
HomeLink before, you should erase
any previously learned codes before
training the first button.
HomeLink stores the code in a
permanent memory. There should
be no need to retrain HomeLink if
your vehicle’s battery goes dead or is
disconnected. If your garage door
opener was manufactured before
April 1982, you may not be able to
program HomeLink to operate it.
They do not have the safety feature
that causes the motor to stop and
reverse if an obstacle is detected
during closing, increasing the risk of
injury.
CONTINUED
On EX and Touring models
HomeLink Universal Transceiver
General Inf ormation
Training HomeLink
Important Saf ety Precautions
Bef ore you begin
Fe
a
tu
re
s
267
Main Menu Table of Contents