HONDA 2005 Odyssey - Owner's Manual - Manual (Page 342)

Remove the two bolt covers on the
rear pillar by prying on the bottom
edge with a flat-tip screwdriver.
Remove the bolts with a Phillips-
head screwdriver, and remove the
light assembly from the rear pillar.
Determine which of the two bulbs
is burned out: turn signal or
brake/taillight.
Remove the socket by turning it
one-quarter turn counterclockwise.
Push the new bulb straight into
the socket until it bottoms.
Test the lights to make sure the
new bulb is working.
Put the socket back into the light
assembly, and turn it clockwise to
lock it in place.
Install the rear light assembly in
the rear pillar. Tighten the two
bolts. Snap the bolt covers into
position.
Remove the bulb by pulling it
straight out of its socket.
2.
3.
5.
6.
7.
1.
4.
Lights
Replacing a Rear Turn Signal or
Brake Light Bulb
Ma
int
e
na
nce
341
Main Menu Table of Contents