HONDA 2003 Pilot - Owner's Manual - Manual (Page 323)

If you are changing the bulb on
the driver’s side, start the engine,
turn the steering wheel all the way
to the right, and turn off the
engine. If you are changing the
bulb on the passenger’s side, turn
the steering wheel to the left.
Use a flat-tipped screwdriver to
remove the five holding clips from
the inner fender.
Pull the inner fender cover away
from the fender and bumper.
Remove the socket from the
headlight assembly by turning it
one-quarter turn counterclockwise.
Pull the burned out bulb straight
out of its socket.
Push the new bulb straight into
the socket until it bottoms.
Insert the socket back into the
headlight assembly. Turn it
clockwise to lock it in place.
Turn on the lights to make sure
the new bulb is working.
Put the inner fender in place.
Install the five holding clips. Lock
each clip in place by pushing on
the center.
1.
2.
3.
4.
8.
6.
7.
5.
Lights
Replacing a Front Side Marker
Light Bulb
Maintenance 319
HOLDING CLIP
Main Menu Table of Contents