HONDA 2003 Pilot - Owner's Manual - Manual (Page 324)

Remove the socket by turning it
one-quarter turn counterclockwise.
Remove the two screws, then pull
the rear light assembly straight
back to remove it from the body.
Determine which of the three
bulbs is burned out: stop/taillight,
turn signal/hazard lights, or side
marker light.
Remove the burned out bulb by
pulling it straight out of its socket.
Install the new bulb into the
socket.
Push the socket into the light
assembly and turn it clockwise
until it locks.
Turn on the lights to make sure
the new bulb is working.
Make sure all the wires are
correctly routed on the rear light
assembly, then install the
assembly on the body.
Open the tailgate. 1.
2.
3.
4.
5.
6.
7.
8.
9.
Lights
Maintenance
Replacing Rear Bulbs
320
Main Menu Table of Contents