HONDA 2000 Accord Coupe - Owner's Manual - Manual (Page 225)

Cooling System
5. When the coolant stops draining,
tighten the drain plug at the
bottom of the radiator.
6. 4-cylinder models
Put a new washer on the drain bolt,
then reinstall the drain bolt in the
engine block. Tighten it securely.
Tightening torque:
61 lbf.ft(83N.m,8.5kgf.m)
6-cylinder models
Tighten the drain bolt at the rear
of the engine cylinder block
securely.
Tightening torque:
7 lbf.ft (10 N.m, 1.0 kgf.m)
7. Mix the recommended antifreeze
with an equal amount of purified
or distilled water in a clean
container. The cooling system
capacity is:
4-cylinder models
With 5-speed manual transmission:
1.45 US gal (5.5 ,1.21 Imp gal)
With automatic transmission:
1.43 US gal (5.4 ,1.19 Imp gal)
6-cylinder models
1.48 US gal (5.6 ,1.23 Imp gal) 8. 4-cylinder models
Loosen the bleeder bolt on top of
the engine.
Pour coolant into the radiator.
Tighten the bleeder bolt when
coolant comes out in a steady
stream with no bubbles.
Maintenance
BLEEDER BOLT
Main Menu Table of Contents