HONDA 2000 Odyssey - Owner's Manual - Manual (Page 249)

Cooling System
4. Install a rubber hose on the drain
bolt in the back of the engine
block. Loosen the drain bolt.
5. Remove the reserve tank from its
holder by pulling it straight up.
Drain the coolant, then put the
tank back in its holder.
6. When the coolant stops draining,
tighten the drain plug at the
bottom of the radiator.
7. Tighten the drain bolt at the rear
of the engine cylinder block
securely.
Tightening torque:
7 lbf.ft (10 N.m,1.0 kgf.m)
8. Mix the recommended antifreeze
with an equal amount of purified
or distilled water in a clean
container. The cooling system
capacity is:
1.74 US gal (6.6 l,1.45 Imp gal)
Maintenance
RESERVE TANK RESERVE
TANK CAP
HOLDER
Main Menu Table of Contents