HONDA 2000 CR-V - Owner's Manual - Manual (Page 257)

Changing a Flat Tire
JACKING POINT
14.Locate the jacking point nearest
the tire you need to change. It is
pointed to by an arrow molded into
the underside of the body. Place
the jack under the jacking point.
Turn the end bracket clockwise
until the top of the jack contacts
the jacking point. Make sure the
jacking point tab is resting in the
jack notch.
EXTENSION
WHEEL WRENCH
15.Use the extension and wheel
wrench as shown to raise the
vehicle until the flat tire is off the
ground.
16.Remove the wheel nuts and flat
tire. Temporarily place the flat tire
on the ground with the outside
surface of the wheel facing up.
You could scratch the wheel if you
put it face clown.
CONTINUED
Taking Care of the Unexpected
Main Menu Table of Contents