Indicator lights – HONDA 2000 CR-V - Owner's Manual User Manual
Page 59
Indicator Lights
U.S.
Anti-lock Brake
System (ABS)
Indicator
Only on models equipped with ABS (see
page
This light normally comes on when
you turn the ignition switch ON (II)
and goes off after the engine starts.
If it comes on at any other time,
there is a problem in the ABS. If this
happens, take the vehicle to your
dealer to have it checked. With the
light on, your vehicle still has normal
braking ability but no anti-lock.
Low Fuel Indicator
This light comes on as a reminder
that you must refuel soon.
High Beam Indicator
This light comes on with the high
information on the headlight
controls.
On Canadian models, this indicator
comes on with reduced brightness
when the Daytime Running Lights
(DRL) are on (see page
).
Cruise Control Indicator
Tailgate-open Indicator
This light comes on if the tailgate is
not closed tightly.
Turn Signal and Hazard Warning
Indicators
The left or right turn signal light
blinks when you signal a lane change
or turn. If the light does not blink or
blinks rapidly, it usually means one
of the turn signal bulbs is burned out
). Replace the bulb as
soon as possible, since other drivers
cannot see that you are signalling.
When you turn on the Hazard
Warning switch, both turn signal
lights blink. All turn signals on the
outside of the vehicle should flash.
Instruments and Controls
Canada
ABS
CRUISE
CONTROL
This lights when you set the cruise
on operating the cruise control.
Main Menu
Table of Contents