IC Realtime 1.3 Megapixel 18X PTZ Network Camera (ICIPMP1801S) - Manual (Page 12)

12
ADDR ：001-H
BAUD RATE ：9600
PARITY ：NONE
PROTOCOL ： PELCO-P
MODEL ：SD66XX
SOFTWARE ：V1.04.3
BACK
EXIT
SYSTEM INFORMATION
DISPLAY SETTING
CAMERA SETTING
FUNCTION SETTING
IR LIGHT SETTING
ALARM SETTING
EXIT
The above diagram illustrates the overall structure of the speed dome setup menu.
Note:
z
ERR means current setup is invalid.
z Please make sure all the cable connections are right.
2.2 Self-diagnosis System Information
After installation, please connect speed dome to power. The system goes on a self-diagnosis, and then it
pops up the above interface to show the system information.
If there is anything wrong during the self-diagnosis, system pops up error code.
The above interface disappears after speed dome received the first command (or the display time lasts for 4
minutes.)
z
ADDR: Here you can view dome address information. For example, 001-H, 1 is the address number, -H
is hard address mode. –S is software address mode.
z Baud rate: Dome communication baud rate.
z Parity: Communication parity bit format.
z Protocol: Current communication protocol.
z Model: Dome type.
z Software: Dome PTZ software version.
2.3 Main Menu
You can open the IP dome menu via control keyboard, matrix, or speed dome control terminal.
z SYSTEM INFORMATION：Dome self-diagnosis information, address information, system time setup,
set north direction, language, factory default setup, reboot and so on.
z DISPLAY INFORMATION: Display dome preset title, azimuth display, time, direction, dome internal
temperature and etc information.
z CAMERA PARAMETERS ：Display dome white balance setup, camera function setup, day/night setup,
shutter setup and etc.
z FUNCTION SETTING: Set preset, pan, scan, auto cruise, pattern, idle motion, time task and privacy mask
function.
z ALARM SETTING: Set dome alarm number, action, contact, preset, scan, cruise, replay out, reset delay,
save setup and etc.
z EXIT: Log out the system menu.