IC Realtime 1.3 Megapixel 18X PTZ Network Camera (ICIPMP1801S) User Manual
Page 19
19
PRESET NO ：001
TITLE ：PRESET001
SETTING
CALL
BACK
2.4.4.1 Preset Setup
Move the cursor to PRESET button and then click confirm button to go to set interface.
z
PRESET NO: Please use left/right key to modify preset number. The different protocols support
different preset values. The PELCOD and PELCOP support 1 to 255. For the industrial protocol, the
value ranges from 1 to 80.
z
TITLE
：Title text is the label used for you to identify the camera. System will automatically name a title
for the camera.
z
SETTING: Please input preset number first and then select the monitor zone. Please move the cursor to
setting and click confirm button. The system will pop up a message: PRESET: ***. Here *** means
preset number. And the SETTING column pops up an OK. Now you successfully added a preset.
Please note, you need to enable display preset title function first (Main menu->display setting->preset
title).Repeat the above procedures to set more presets. Once you want to modify a preset, you can
input the preset number you want to modify and then follow the above steps to set the preset. You can
successfully modify a preset content.
z
CALL: Here is to recall preset. Move the cursor to PRESET NO and then input corresponding preset
value. Then move the cursor to CALL and then click confirm button to go to a preset.
z
BACK: Go back to previous menu.
z
EXIT: Log out system menu.
For PELCO protocol user, please refer to the following special functions:
z
Call preset: Call preset 28 or preset 95 to go to dome menu. Call preset 29 or preset 99 to go to scan.
Call preset 24 or preset 81 to go to pattern. Call preset 25 or preset 82 to go to cruise (tour). Call preset
30 or preset 96 to stop scan or pattern. Call preset 31 or preset 83 to begin rotation. Call preset 33 to
enable PTZ 180 degrees rotation. Call preset 34 to set dome position as 0.
z
Set preset: Set preset 26 or 92 to set scan left limit. Set preset 27 or 93 to set scan right limit. Set
preset 22 or 79 to begin record. Set preset 23 or 80 to stop record.
2.4.4.2 Pan
Move the cursor to PAN button and then click confirm button to go to setup interface.
z
PAN SPEED: Set dome rotation speed. Please use the left/right button on the keyboard or in the speed
dome terminal menu to set.
z
RUN: Move the cursor to call item and then click confirm button. The dome begins 360 degrees
continuous rotation.
z
STOP: Highlight stop item and then click confirm button. The dome stops rotation.
z
BACK: Go back to previous menu.
PAN SPEED ：160
RUN
STOP
BACK
EXIT