IC Realtime 1.3 Megapixel 18X PTZ Network Camera (ICIPMP1801S) User Manual
Page 25
25
POWER UP ：1
PARAMTER ：OFF
BACK
EXIT
Note:
z
For security reasons, please set privacy zone a little bit larger than the privacy object size.
z
Each time, after modifications you need to move the cursor to SAVE button and then click confirm
button to get all setup activated. Otherwise, privacy zone may not move correspondingly with the object.
Please enter privacy mask menu, now all the privacy zones are closed.
Move the cursor to PRIVACY NO, please use left/right key to set different privacy zones.
For example, shift to 001 section and then move the cursor to ACTIVATE.
Secondly, use left/right key to select ON mode. Now there is a privacy zone in the screen centre.
Thirdly, use PTZ to move camera so that privacy object fit well with screen centre.
Fourthly, move the cursor to RESIZE and then click left and right key to adjust privacy zone direction and
size.
Fifthly, move the cursor to SAVE and then click confirm button to exit.
z
PRIVACY
NO
：Here is to set privacy mask zones. Please use the left/right button on the keyboard or in
the speed dome terminal menu to set. The value ranges from 1 to 24.Please note the value here may
vary due to different protocols.
z
ACTIVATE: There are two settings: on and off. When activate function is on, the privacy mask function
will be activated and displays in the screen. When activate function is off, the privacy mask function will
be closed and the blank will not displayed in the screen.
z
RESIZE
：It is to adjust the privacy zone size. Please continue pressing direction button to widen or
narrow zone size. ← is to narrow the horizontal width and → is to widen the horizontal width. ↑ is to
widen vertical height and ↓ is to narrow the vertical height.
z
SAVE
：Here is to save user setup.
z
DELETE: Here is to delete setup and restore default setting.
z
BACK: Go back to previous menu.
z
EXIT: Log out system menu.
Power Up
Move the cursor to the POWER UP item and then click the confirm button, you can go to the fourth
menu.
• POWER UP: It is to set the PTZ operation when the speed dome boots up. The option includes:
NONE/AUTO/SCAN/PRESET/PATTERN/TOUR and etc. Please use the left/right button to set.
• PARAMTER: Here you can set the serial number of the corresponding operation such as the scan,
preset, pattern, tour. Please use the left/right button to set.
PRIVACY NO ：001
ACTIVATE : OFF
RESIZE : ↑
DELETE
SAVE
BACK
EXIT