Vertical Communications TeleVantage 7.5 - Manual (Page 63)

C HAPTER 6. I NSTALLING I NTEL D IALOGIC B OARDS 6-11
Connecting Internet telephony boards and VoIP phones
If you are using Internet telephony boards, connect the built-in Network Interface Card (NIC)
on each board to your network using a standard Ethernet cable.
Connecting SIP phones, H.323 phones, and IP gateways
Connect the following to your network using an Ethernet cable:
Q SIP desktop phones
Q H.323 phones
Q VoIP gateway devices that provide PSTN/Foreign eXchange Office (FXO) ports,
station/Foreign eXchange Station (FXS) ports, and T1, E1, and BRI ports. (For more
information, see the device manufacturer’s documentation.)
Q Intel NetStructure PBX-IP media gateway
Your TeleVantage Server must also be connected to your network via Ethernet.
For information about using VoIP with TeleVantage, see the following in Administering
TeleVantage:
Q Chapter 14, “Configuring SIP Internet Telephony”
Q Chapter 15, “Configuring H.323 Internet Telephony”
When you have connected all of your Internet telephony boards, go to the next section.
Connecting station boards and phones ______________________
This section describes how to connect the following:
Q Analog station boards and phones. See page 6-11.
Q Digital station boards and phones. See page 6-14.
Q Toshiba digital station boards and phones. See page 6-17.
Connecting analog station boards and phones
This section describes how to connect MSI/x, DISIx, HDSI/x, and DI0408LSAR2 station
boards, as well as how to connect the power supply for MSI/x or DISIx station boards. See
“Analog phone and Toshiba digital phone wiring requirements” in Chapter 5 in Installing
TeleVantage for more information about wiring options.