Vertical Communications TeleVantage 7.5 - Manual (Page 75)

C HAPTER 7. I NSTALLING I NTEL D IALOGIC B OARD D RIVERS 7-3
Task checklist
You must perform the tasks listed in the following table in the order specified. This list is only
an overview of the tasks you must perform. Detailed instructions for each task are presented in
later sections in this chapter.
Preparing to install Intel Dialogic SR 5.1.1 ____________________
To prepare your TeleVantage Server PC for the Intel Dialogic SR 5.1.1 installation, perform the
following steps:
1. Start the TeleVantage Server PC and log on as a user with administrator privileges to
the Windows Server on that PC.
2. If you are using a non-English version of Windows , create the directory C:\Program
Files , if it does not already exist. Doing so prevents Intel Dialogic error messages
during the installation.
3. Insert the TeleVantage Intel Dialogic CD. If the Driver Setup does not start
automatically, run
autorun.exe from the root directory on the Intel Dialogic CD. Note
that this manual does not describe all Driver Setup screens in detail.
Note: If you are installing TeleVantage from a zip file that you downloaded, run the
Driver Setup program manually from the CD image that you extracted to your
TeleVantage Server’s hard drive.
Note: If the message “Corrupt installation detected” appears after you insert the CD or
run autorun.exe, log on as a local administrator, and then reinsert the CD.
Step Description
1 Uninstall your current Intel Dialogic Drivers, if you are upgrading from a previous
version of TeleVantage.
2 Install Intel Dialogic SR 5.1.1.
3 Install Intel Dialogic SR 5.1.1 FP1 SU.
4 Install TeleVantage SR 5.1.1 Driver Updates.
5 Install Intel Dialogic DSI board drivers, if you are using Intel Dialogic DSI boards to
support digital phones.
6 Install Intel Dialogic GlobalCall 4.3, if you are using E1 CAS protocols.
7 Perform board-specific configuration steps, as described in the table on page 7-19.
8 Test-start the Intel Dialogic drivers
9 If you have an ISDN line, verify that it is working correctly.
10 If you are using Robbed Bit T1 trunks, configure Robbed Bit T1 signaling.