Interlogix Concord Express User Manual - Manual (Page 30)

24 Concord Express User Instructions
Programming Access Codes
User codes can be given certain attributes which determine whether the user can
bypass a sensor or perform system tests.
Changing a User Code
To change or assign a user access code:
Note
: The system will not accept the same code for two different users.
1. Enter the programming menus by pressing 9 + System Master Code.
2. Press 10 nn 0 where nn is user 00 through 15.
3. Enter the desired 4-digit code, then # .
4. Press * + 4 + # to exit the programming menus.
Erasing a User Code
When a code is deleted from the system, that code no longer acts as a key for
operating the system in any manner.
To erase a user code:
1. Enter the programming menus by pressing 9 + System Master Code.
2. Press 10 n n 0 where nn is user 00 through 15.
3. Enter the System Master code, then # .
4. Press * + 4 + # to exit the programming menus.
Assigning the Direct Bypassing Attribute
Direct Bypassing is a user code attribute that allows the user to bypass open
sensors. If the user code does not have this attribute turned on, the user will not
be able to bypass sensors directly.
To assign Direct Bypassing to a user:
1. Enter the programming menus by pressing 9 + System Master Code.
2. Press 10 n n 1 where nn is user 00 through 15.
3. To turn Direct Bypassing
on, press 2 + # .
off, press 1 + # .
4. Press * + 4 + # to exit the programming menus.