Interlogix NX-148E - Manual (Page 16)

NX-148E LCD Keypad 14
PROMPT
Outputs used? DO NOT CHANGE THIS SEGMENT!
Open / Close Rprt?
Bypass enable?
Arm / Disarm?
(These are for use by a professional installer only.)
Master code?
Sched arm only?
Arm only?
Reserved
0=No 1=Yes
Your keypress will apply to the user code you entered in Step 3.
Output 4 ?
Output 3 ?
Output 2 ?
Output 1?
If these messages appear on the LCD screen, press the [
r
] key
until you return to the prompt for the user code or until you
exit this adjust mode.
Step 4
NOTE: The LCD will now display all of the partitions to which this user has
access. If you wish to remove a partition, press the partition number on the
keypad, and the display will mark that partition with a (-) hyphen indicating
access has been removed. If you wish to re-establish user access to the
partition, press the partition number again.
Step 5 Press r to save the data. The LCD will then prompt you for the next user
code.
Step 6 If another user code needs to be programmed, return to Step 3. If not, press
# to exit this feature without saving the data.
RESET FUNCTION
This function is used to reset Smoke Detectors, Zone Troubles, and Zone Tampers.
Step 1 Disarm the system if it is not already disarmed.
Step 2 Press r 7 . Resets have now been performed.
Step 3 If the keypad begins beeping, the reset did not execute properly. Enter
your code to silence the keypad. Wait a few minutes and repeat step 2 to
attempt another reset. If the keypad still beeps after repeated attempts,
please contact your installer.