Interlogix NX-148E - Manual (Page 25)

NX-148E LCD Keypad 23
VII. APPENDIX A - EVENT LOG
NOTE: Your system may not have all of the features listed in this table.
DISPLAY DESCRIPTION
TXlobat Transmitter
Low Battery The transmitter has a low battery.
ZN Lost Zone Lost A wireless or multiplexed zone device is not
reporting to the control.
Duress Duress The control has been armed or disarmed with a
Duress code.
Man Fire Manual Fire Keypad “Fire” has been activated.
Aux 2 Auxiliary 2 Keypad “Medical” has been activated.
Panic Panic Keypad “Panic” has been activated.
KP Tamper Keypad Tamper The keypad tamper has been activated.
BoxTamp Box Tamper The box tamper circuit has been activated.
AC Fail AC Fail AC failure has been detected.
OverCur Over Current A short circuit of a power supply has occurred.
Srn Tamp Siren Tamper A siren or speaker tamper has been detected.
Tel Flt Telephone Fault A telephone fault or tamper has been detected.
Exp Trb Expansion
Trouble An expansion device or keypad is not reporting to
the control.
Log Full Log Full The event log is full. Old events will be pushed out
as new ones enter the log.
Open Open Reports user number, date, time and partition of
opening.
Close Close Reports user number, date, time and partition of
closing.
Exit Err Exit Error Entry/Exit zone was faulted at the instant the exit
delay expired.
Rec Close Recent Close An alarm occurred within 5 minutes after the
control was armed.
Autotest Auto Test Sending a communicator test at a specified
interval.
Start Prog Start
Programming Local programming is started.
End Prog End
Programming Local programming is ended.
Start Dnld Start Download Download session is started.
End Dnld End Download Download session is ended.