Interlogix NX-148E - Manual (Page 26)

NX-148E LCD Keypad 24
DISPLAY DESCRIPTION
Cancel Cancel System is disarmed and the Cancel button was
pressed within 5 minutes of an alarm.
Gnd Flt Ground Fault A short to ground has been detected.
Man Test Manual Test Bell and/or communicator test while system is in
disarmed condition.
Re-exit Re-Exit The exit delay has been re-started without
disarming the system.
Output Trip Output Trip A trip has occurred on an expander auxiliary
output.
Data Lost Data Lost Communication of a signal has failed (log only
event).
Walk-test Walk-Test A zone “Walk-Test” mode has been activated.
End Test End Test Test has been ended.
Cross-Trip Cross Trip The first zone of a cross zone has been tripped (log
only).
Expansion
Event Expansion Event An expansion module created an undefined event.
Partial Arm Partial Arm Reports a closing in the stay mode.
Listen In Listen In A listen in function has been activated.
Service Start Service Start Technician is on site.
Service End Service End Technician is off site.
Code Entry Code Entry A code has been entered.
First Open First Open Reports when the first partition is disarmed.
Last Close Last Close Reports when the last partition is armed.
Sprnklr Sprinkler Instant sprinkler supervisory report
Clock Set Clock Set Clock has been reset.
RF Jammed RF Jammed A wireless expansion module is jammed
CleanMe CleanMe A smoke detector requires cleaning.