Dvd to videotape duplication 39, Press dvd. press play ► to play the disc, To stop recording, press vcr, then press stop – Philips DVP620VR/17 User Manual
Page 39: Dvd to videotape duplication, Helpful hints
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
H9620UD_1_47,qx4 04.4.7
11:57 AM Page 39
DVD to Videotape Duplication 39
Follow the steps below to copy a DVD to a videotape. This
will be possible only if the DVD is not copy protected.
Before you begin:
♦ Put a videotape in the cassette compartment. Make sure the
tape’s record tab is intact and the tape is long enough to
record the DVD.
♦ Put the DVD you want to copy in the disc tray.
♦ Press VCR so the VCR light appears on the front of the
DVD/VCR.
♦ Turn on the TV and set it to channel 3,4, or its Video |
Input.
^
Point the remote control at the DVD/VCR. Press
Number buttons 0,0,3. “DISC” will appear on the TV
screen.
/
N
DISC
V
J
Press SPEED until the desired tape speed (SP or
SLP) appears briefly on the screen. Details about
tape speed are on page 72.
Press RECORD • to start recording. ‘REC will
appear on the display panel.
Press DVD. Press PLAY ► to play the disc.
To pause the recording, press VCR, then press
PAUSE 11 once. REC will flash. To resume recording,
press RECORD • or press PAUSE 11 again. REC will
reappear.
To stop recording, press VCR, then press STOP ■.
Helpful Hints
A timer recording is not possible
during DVD to videotape
duplication.
You cannot copy a DVD to a
videotape if you are using
Progressive Scan. Details are on
page 12.