Canon W7250 - Manual (Page 57)

9 Adjusting the Printing
45
1-45
Important
Note
Adjusting Amount of Media Feed
The amount of feed is adjusted for each media type. Printing Pattern B sets
the amount of feed for the currently selected media type. Before printing,
make sure that A3 or larger roll media is set. If you are using the W7250
without the stand, make sure that A3 or larger cut sheet is set.
z Before adjusting the amount of media feed, you must select the correct Roll Media
Setting in the operation panel for the roll media loaded in the printer. If the “Roll
Media Type” selection is incorrect for the roll media set in the printer, this could
cause poor print quality.
z Only Cut Sheet should be used with the W7250 without the stand. For details about
loading cut sheets, see "Loading Cut Sheets" in Chapter 2 of the User's Guide. It is
possible to use both Roll Media and Cut Sheet with the W7200 and the W7250
with the stand.
z If you are using a cut sheet, make sure at least one sheet of unused A3 paper (not
the blank side of used paper) or larger is set.
1
If the printer is off, press the Power button to switch the printer on.
After a few seconds “Online” is displayed in the operation panel and the
Online lamp lights.
2
Press the Online button twice to display “MAIN MENU”.
Enter Cancel
Cut Sheet
Roll Media
Paper Source Data Message Power
Online
Enter Cancel
Cut Sheet
Roll Media
Paper Source Data Message Power
Online