Compaq R6000 - Manual (Page 66)

Configuration 4-11
X Alarms
UPS on Battery
Load Power Off
When the UPS is no longer protecting its load devices and there is no utility
voltage powering the devices, the UPS will trigger an alarm.
X Alarms
Load Power Off
Battery Test Failed
Periodically, the Compaq UPS microprocessor initiates a brief discharge cycle
to check the charge level of the battery packs. If this test fails, the UPS will
trigger an alarm, indicating that battery replacement is imminent.
X Alarms
Battery Self-Test Failed
Site Wiring Fault
This alarm is triggered when either there is no ground connection between
utility power and the UPS, or the line and neutral connections between utility
power and the UPS are reversed. This is disabled for 200V and 208V.
X Alarms
Site Wiring Fault
Battery Data
Main Menu
→ Battery Data
Also under Main Menu is Battery Data, displaying, in 10% increments, the
amount of charge on the battery. If the UPS is in Battery mode, the graph