Philips 30PF9946-37 - Manual (Page 20)

DVI connector (AV5)
DVI is a specific digital input allowing
encrypted transmission of
uncompressed HD content. DVI
includes HDCP (high-bandwidth
digital content protection), which is
supported by Hollywood, satellite
providers, and most of the consumer
electronics industry. DVI is gaining
monumentum and quickly becoming
an industry standard for the
consumers to view high-definition
material while keeping content
protected.
The DVI IN connector allows
- the following TV and monitor display modes:
EDTV 640/720 X 480p
720 X 576p
HDTV 1920 xIOSOi
VGA 640 X 480 60 Hz
SVGA 800 X 600 56 Hz
XGA 1024 X 768 60 Hz
- uncompressed HD content
- encrypted or non encrypted signals.
Note: Only Single Digital Link DVI is supported.
O Connect the digital DVI output of your HD device (e.g.
PC, DVD player. Set Top Box..) to the DVI IN connector
of your TV.
0 Connect the audio cable @ of your HD device (if
audio is present) to the AUDIO outputs of your HD
device and to the AUDIO R (right) and L (left) inputs of
the panel of the TV.
Notes:
- Proper working is only guaranteed with DVI compliant consumer
products.
- Digital devices from different manufacturers have the possibility
of differing output standards which may cause difficulties for the
television to properly display;
- If the set is cold, there may be a small “flicker” when the set is
turned on. this is normal, there is nothing wrong with the set
- If possible, use the VESA 1024x768@60Hz video mode to
obtain the best image quality for your LCD monitor.
Multi channel Surround receiver
CENTRE IN — 1 1
o j o j
■ > “"'S®
, AUDIO
---------- -OUT
.... i
■ :■ i
©
^ 0.
03 ca
0 Connect the audio cable to the multi channel Surround receiver
and to AUDIO OUT L and R below the CENTRE IN connector
of your TV ^.
Note: turn off the TV and your surround receiver before connecting
them. Set the Surround receiver’s volume to minimum.
o If you want the loudspeakers of your monitor to act as center
speaker, also connect an audiocable to the multi channel
Surround receiver and to the CENTRE IN of your TV
0 Select Center input On in the Source menu. See p. 7.
The loudspeakers of the TV will now only produce center
sound, the loudspeakers connected to the audio receiver will
produce Surround Sound.The volume has to be controlled via
the multi channel Surround receiver.
Note: No sound will be heard when a TV channel or external source is
blocked via the Channel Lock menu (see p. 11).
17