Cisco 2975 - Manual (Page 32)

2-14
Catalyst 2975 Switch Hardware Installation Guide
OL-17784-01
Chapter 2 Switch Installation
Installing the Switch
Attaching the RPS Connector Cover
If you are not using an RPS with your switch, use the two Phillips pan-head screws to attach the RPS
connector cover to the back of the switch (
Figure 2-14 ).
Warning If an RPS is not connected to the switch, install an RPS connector cover on the back of the switch.
Statement 265
Figure 2-14 Attaching the RPS Connector Cover
1 Phillips pan-head screws 3 RPS connector
2 RPS connector cover
CONSOLE
DC INPUT S FOR RE MOTE POWER SU PPLY SPECIFIED IN MANU AL
STACK 1
STACK 2
272685
2 1
3